Windows, Propane Lockers, Hatches and Non-Skid

Project is coming along nicely, if slowly. I took a one-week vacation from my 9 to 5 job to fill and sand decks and cabin. The first coat of primer applied last week exposed a million plus pin holes in the surface but we are a week closer to final primer now. The yard owner graciously allowed me to work at my own slow pace for the entire week.

epoxyfill

Replacement windows (PVC frames with ½-inch tempered reflective bronze tint glazing) delivered this week from Mark Plastics in Corona, CA .

windows

The builder and I have come to an agreement on propane lockers. Eight-inch fiberglass tubes will be glassed into the stern quarters and fitted with flush mounted deck plates from Viking Marine aft of the port and stbd. cockpit lockers.

The builder noted that the companion way hatch was weak (thin) and will beef this up with foam and glass on the underside so I can stand on it to reef the main without it flexing.   He has done the same for the engine access hatch over in the cockpit sole and the forward hatch.

hatches

A decision was made to fabricate cockpit locker hatches from fiberglass to replace the existing composite board hatch covers dictated by my preference to have a uniform non-skid appearance in the cockpit. The locker covers (3) will have the same radius as the cockpit well and fit flush with the well sides.

The non-skid areas will use a nylon net encapsulated in resin. Samples are good looking, tough and easy on the knees.

nonskid1

Good night . . . .   Working under the sun in hot and humid weather with no air is not my idea of fun. Here is my baby all wrapped up for the night.

wrappedup